Subject: Re: pre4: can not run ./config.sub
From: Thomas Schierle (ts@visual-s.de)
Date: Mon Feb 26 2001 - 18:25:22 EST
On 01-02-26 09:16 +0100, REYNAUD Jean-Samuel <reynaud@nantes.inra.fr> wrote:
>
> On 2001.02.25 18:59:03 +0100 Thomas Schierle wrote:
>> Hello all,
>>
>> because the pre4.rpm from sourceforge refuses to install
>> onto my suse 7.0 box, I tried to compile from the .tar archive.
>>
>> Since I didn't compile even a single line of code before and
>> my linux knowledge is quite poor, the following error message
>> leaves me sitting clueless in front of the screen:
>>
>>> bob:~/ntalk15pre04/netatalk # ./configure
>>> loading cache ./config.cache
>>> configure: error: can not run ./config.sub
>>
>> Could please anybody point me into the right direction?
>>
> aclocal/autoconf/automake/libtools tools must be installed
> (in this tar, config.sub is a link :
> lrwxrwxrwx 1 other other 29 Feb 26 09:11 config.sub -> config.sub)
> check the directory /usr/share/libtool/
Thanks, Jean-Samuel -- I have:
/usr/share/autoconf
/usr/share/automake
/usr/share/aclocal
filled with all kinds of nifty stuff :-)
in fact, there is no /usr/share/libtools directory ...
At the suse install CD, I was able to find a package named
"libtool", (Tool to create "shared libraries"). I'll install
right now and see if I get pre4 compiled tomorrow.
Again, thanks a lot, I for sure would not have been able
to figure out the missing piece on my own.
-Thomas
... a couple of minutes later: I was able to configure
without any problems :-)))
-- Thomas Schierle, Munich, GermanyPGP key [DSS/DH] 0xA23CDA1D available at various public key servers
This archive was generated by hypermail 2b28 : Sun Oct 14 2001 - 03:04:33 EDT