Subject: Re: Poor netatalk performance
From: Jonathan Paisley (jonp@chem.gla.ac.uk)
Date: Fri Jul 20 2001 - 05:22:09 EDT
That syslog message looks like you might have the two ethernet cards on
the same physical network. Is that the case? Are they plugged into the
same hub/switch? If so, it's not going to work... [I think]
On Fri, 20 Jul 2001, Lasse Lehtinen wrote:
> On Thu, 19 Jul 2001, Thomas Kaiser wrote:
>
> > If you want to use both NICs für AppleTalk you must configure them (netatalk
> > will be an appletalk router afterwards)
> >
> > I would recommend the following:
> >
> > eth0 -seed -phase 2 -net 1-1000 -addr 1000.142 -zone "eth0"
> > eth1 -seed -phase 2 -net 1001-2000 -addr 2000.142 -zone "eth1"
>
> I tried and I got following errors:
>
> Jul 20 14:49:32 pc1-1633 atalkd[12091]: restart (1.5pre6)
> Jul 20 14:49:33 pc1-1633 atalkd[12091]: zip_getnetinfo for eth0
> Jul 20 14:49:52 pc1-1633 last message repeated 2 times
> Jul 20 14:50:02 pc1-1633 atalkd[12091]: as_timer configured eth0 phase 2
> from seed
> Jul 20 14:50:03 pc1-1633 atalkd[12091]: zip_getnetinfo for eth1
> Jul 20 14:50:03 pc1-1633 last message repeated 2 times
> Jul 20 14:50:03 pc1-1633 atalkd[12091]: rtmp_packet interface mismatch
> Jul 20 14:50:03 pc1-1633 atalkd[12091]: default zone mismatch on eth1
> Jul 20 14:50:03 pc1-1633 atalkd[12091]: eth1 != eth0
> Jul 20 14:50:03 pc1-1633 atalkd[12091]: Seed error! Exiting!
> Jul 20 14:50:03 pc1-1633 atalkd[12091]: ap->ap_packet: Success
> Jul 20 14:50:03 pc1-1633 atalkd: AppleTalk not up! Check your syslog for
> the reason. Child exited with 1.
> Jul 20 14:50:03 pc1-1633 atalk: atalkd startup failed
> Jul 20 14:50:03 pc1-1633 afpd[12101]: main: atp_open: Cannot assign
> requested address
> Jul 20 14:50:03 pc1-1633 atalk: afpd startup succeeded
> Jul 20 14:50:03 pc1-1633 afpd[12101]: ASIP started on
> 212.246.246.194:548(0) (1.5pre6)
> Jul 20 14:50:03 pc1-1633 afpd[12101]: uam: uams_randnum.so loaded
> Jul 20 14:50:03 pc1-1633 afpd[12101]: uam: "2-Way Randnum
> exchange" available
> Jul 20 14:50:03 pc1-1633 afpd[12101]: uam: "Randnum exchange" available
>
> Once I got the boths zones working, but after a couple of restarts it
> stopped once again. During that, the transfer speeds we're still the same.
> I also checked the atalkd.conf and noticed that it had been altered. Does
> netatalk configure it automatically?
>
>
-- Jonathan Paisley jonp@chem.gla.ac.uk
This archive was generated by hypermail 2b28 : Sun Oct 14 2001 - 03:04:45 EDT