Subject: Re: Performance problem with multi-user
From: Matthew Keller (kellermg@potsdam.edu)
Date: Mon Oct 01 2001 - 21:14:38 EDT
Few things:
1) 2.4.9 kernel + Ext2fs (which I'm assuming you're using) has some I/O
issues **ESPECIALLY** if you've got quota's enabled. Try disabling
quotas if active. Also, upgrade to 2.4.10 when possible.
2) Is sda1 your root disk? Performance will always be worse on those
because of other I/O ops related to running the OS (esp if X is running)
3) Try the same tests using a different protocol (HTTP, SMB) -- If
other servers serve the same concurrency at better rates, or not, it
tells you something. This is comparing apples and oranges (excuse the
pun) but the statistic ratios should be nearly the same.
4) I hope you're using ASIP to do this transfer and not AppleTalk -- If
not, please do.
On Mon, 2001-10-01 at 20:24, Jason Lam wrote:
> I am trying to build a high performance netatalk server for serveral Mac
> clients. The initial test with single clients yield more than 10MB/s which
> was amazing. However, when testing with multi concurrent user, the test
> results are not very impressive.
>
> On Linux server side, I have an Adaptec 29160 controller hooked up with an
> IBM 10K 36G HDD running at 160MB/s. When doing hdparm, I got the following
> results.
>
> /dev/sda1:
> Timing buffer-cache reads: 128 MB in 0.99 seconds =129.29 MB/sec
> Timing buffered disk reads: 64 MB in 1.88 seconds = 34.04 MB/sec
>
> This mean I should have enough I/O performance for two concurrent user to be
> going full speed. And I have a gigabit ethernet card hooked up to a switch.
>
> On the Mac side, it's G4 and 10/100 network card.
>
> When doing concurrent download, both clients login with same username and
> download different files. I only get about 5.7MB/s on each one which is like
> a 10/100 shared performance. I was thinking about problem with gigabit
> network interface at that point, so I did another test, created another user
> whose home dir is on another IDE HDD. (Similar result when testing on IDE
> drive alone) When I do the concurrently download, I am able to get about
> 10MB/s from each of the workstation.
>
> This tells me I am not having problem with the network card but some other
> multi-user problem with regard to I/O on a single device. BTW, kernel
> version is 2.4.9 and netatalk is 1.5pre6.
>
> Can anyone suggest where to start performance tuning this server? Did I miss
> anything plain and stupid (my setup are pretty much stock). A few things
> that came to my mind is bdflush and elvtune, can anyone supply some example
> settings that works great with netatalk?
>
> Any suggestions to tuning the performance of this server will be greatly
> appreciated.
>
> Jason Lam
>
>
--Matthew Keller Enterprise System Analyst Computing & Technology Services Information Services Division State University of NY at Potsdam Potsdam, NY USA
This archive was generated by hypermail 2b28 : Sun Oct 14 2001 - 03:04:54 EDT